:	Jul 8, 2004

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the LH exhaust manifold.

.

Release the starter motor cable.   Release the terminal cover.   Remove the terminal nut insulator.   Remove the nut.

.

: Protect the engine during this operation. Remove the engine mount bracket.   Support the engine.   Remove the 4 bolts.

.

Remove the engine mount.   Remove and discard the 2 bolts.

.

Install the engine mount.   Clean the component mating faces.   Tighten the new bolts to 45 Nm (33 lb.ft), then a further 60 degrees.

.

Install the engine mount bracket.   Clean the component mating faces.   Tighten the bolts to 80 Nm (59 lb.ft).   Remove the engine support.

.

Connect the starter motor cable.   Tighten the nut to 10 Nm (7 lb.ft).   Install the terminal nut insulator.   Install the cover.

.

Install the exhaust manifold.

.

Connect the battery ground cable.